Reset; Hardware Reset 1; Reset On A Stable Supply Voltage; Power-On Reset - Renesas M16C/62P Series Hardware Manual

M16C/62P Group (M16C/62P, M16C/62PT)
5.

Reset

Hardware reset 1, brown-out detection reset (hardware reset 2), software reset, watchdog timer reset and oscillation
stop detection reset are available to reset the microcomputer.
5.1

Hardware Reset 1

The microcomputer resets pins, the CPU and SFR by setting the RESET pin. If the supply voltage meets the
recommended operating conditions, the microcomputer resets all pins when an "L" signal is applied to the RESET
pin (see Table 5.1 Pin Status When RESET Pin Level is "L"). The oscillation circuit is also reset and the main
clock starts oscillation. The microcomputer resets the CPU and SFR when the signal applied to the RESET pin
changes low ("L") to high ("H"). The microcomputer executes the program in an address indicated by the reset
vector. The internal RAM is not reset. When an "L" signal is applied to the RESET pin while writing data to the
internal RAM, the internal RAM is in an indeterminate state.
Figure 5.1 shows an Example Reset Circuit. Figure 5.2 shows a Reset Sequence. Table 5.1 lists Pin Status When
RESET Pin Level is "L". Figure 5.3 shows CPU Register Status After Reset. Refer to 4. Special Function
Register (SFR) for SFR states after reset.
5.1.1

Reset on a Stable Supply Voltage

(1) Apply "L" to the RESET pin
(2) Apply 20 or more clock cycles to the XIN pin
(3) Apply an "H" signal to the RESET pin
5.1.2

Power-on Reset

(1) Apply "L" to the RESET pin
(2) Raise the supply voltage to the recommended operating level
(3) Insert td(P-R) ms as wait time for the internal voltage to stabilize
(4) Apply 20 or more clock cycles to the XIN pin
(5) Apply "H" to the RESET pin

RESET

NOTES:
1. If VCC1>VCC2, the VCC2 voltage must be lower than that of VCC1 when the power
is being turned on or off.
Figure 5.1 Example Reset Circuit
Rev.2.41 Jan 10, 2006
REJ09B0185-0241
http://www.xinpian.net
Recommended
operation voltage
VCC1
0V
VCC1
RESET
0V
Page 40 of 390
提供单片机解密、IC解密、芯片解密业务
0.2VCC1
or below
0.2VCC1 or below
Supply a clock with td(P-R) + 20
or more cycles to the XIN pin
5. Reset
010-62245566 13810019655