Advanced Teachin Settings; Advanced Image Settings - ABB FlexLoader Vision Product Manual

5 Advanced teachin settings

5.1 Advanced image settings

Introduction
The teachin steps described in the previous section are usually adequate to provide
a fully functional teachin setup. However, under certain circumstances it may be
necessary to make additional settings for optimal teachin. Some of the additional
settings available are described in the following chapter.
If it is difficult to obtain an image with good contrast, additional settings for adjusting
the image can be accessed by clicking on Advanced on the Image tab.
Here the user can also configure detail specific movement supervision to prevent
the details from moving after the images are taken.
xx1800000231
Filtering
With the advanced image settings you can radically change the appearance of an
image by adding one or more filters before the image is analyzed further. This can
be especially useful in cases where the image is very uniform or the detail is not
clearly defined against the background, etc.
Up to three filter steps can be applied one after the other. Note that the results can
differ widely depending on the order in which the filters are applied. This gives a
large number of possible combinations. The effect of a filter is immediately seen
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
© Copyright 2014-2018 ABB. All rights reserved.
5 Advanced teachin settings
5.1 Advanced image settings
Continues on next page
63