Positions - ABB FlexLoader Vision Product Manual

4 Teachin

4.5 Positions

4.5 Positions
A detail can often lie in a number of different positions. These must be defined on
the Positions tab. In the example below we teach the system to recognize the text
FlexLoader Vision. The text can lie in two positions, either the right way up or
mirrored. Clicking on the button New position creates a new position. This position
must be defined by drawing a red box around the detail in the field of view that
corresponds to the position. This is done using the Define position tool. Note that
a position will be identified even if it is lying in a different angle (rotated) than it
was at teachin.
xx1800000212
The next position is defined by clicking on New position again and drawing a box
around the detail with the mirrored text.
Continues on next page
32
© Copyright 2014-2018 ABB. All rights reserved.
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B