Changing Flexpendant Settings; System Settings; Setting Default Paths - ABB IRC5 with FlexPendant Operating Manual

3 Navigating and handling FlexPendant

3.7.1.1 Setting default paths

3.7 Changing FlexPendant settings

3.7.1 System settings

3.7.1.1 Setting default paths
Introduction to default paths
You can set individual default paths for some actions using the FlexPendant.
The following default paths can be set:
This function is available if the user that is logged on is authorized. User
authorization is handled via RobotStudio. See Operating manual - RobotStudio.
Setting default paths
Use this procedure to set a default path.
1
2
3
4
5
6
100
• Saving and loading RAPID programs.
• Saving and loading RAPID modules.
• Saving and storing configuration files.
Action
On the ABB menu, tap Control Panel and then FlexPendant.
Tap File System Default Path.
en0500002361
Tap the File type menu to choose type of default path:
• RAPID programs
• RAPID modules
• Configurations files
Type the default path or tap Browse, to choose the desired location.
If required, any previously entered path can be removed by tapping Clear.
Tap OK.
© Copyright 2018 ABB. All rights reserved.
Operating manual - IRC5 with FlexPendant
3HAC050941-001 Revision: G