ABB FlexLoader Vision Product Manual page 79

Parameter
Black[0] / White [1]
Intensity threshold
Requirements
Example: Black[0] / White [1] = 1, Requirements = 40%, Intensity threshold =
80%
An analysis with the above settings would include all pixels within the red box with
an brightness intensity above 80%. If more than 40% of the pixels in the red box
meet the conditions, the analysis is approved.
EdgeCheck
The analysis type EdgeCheck (if enabled) is used to ensure that the selected parts
of the detail position consist of a certain amount of edges, i.e. visible structures.
This could be used, for example, to check for holes, embossing, or large defects
on a flat surface.
xx1800000238
Parameter
Even [0] / Structured [1]
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
Description
Indicates whether the operator is interested in the light
(1) or dark areas (0). During testing, the pixels above
the intensity threshold (1) or those below the intensity
threshold (0) are marked.
Indicates at which brightness level the pixels are in-
cluded in the analysis. 100% corresponds to a com-
pletely white pixel and 0% to a completely black pixel.
Specifies what percentage of the pixels must meet the
conditions above.
Description
Indicates whether the operator is interested in flat
areas or structured areas of the surface. During testing,
the pixels with an edge strength below the edge intens-
ity threshold (1) or those above the edge intensity
threshold (1) are marked.
© Copyright 2014-2018 ABB. All rights reserved.
5 Advanced teachin settings
5.3.4 AddOn analysis
Continues on next page
Continued
79