Settings - ABB FlexLoader Vision Product Manual

11.3.2 Settings

Basic network settings
FlexLoader systems use the following standard network settings.
Internal machine network
The FlexLoader Vision PC is connected to the robots internal network, together
with other equipment like PLCs, frequency converters and I/O-boards.
The PC network connection is named Robot on physical port LAN. The following
standard settings are used:
Equipment
PC
Robot
PLC camera 1
PLC camera 2
PLC camera 3
PLC camera 4
Internal camera network
The FlexLoader Vision PC is connected to the cameras on a separate internal
network.
The PC network connection is named GigE on physical port PoE1. The following
standard settings are used:
Equipment
PC
Camera 1
Camera 2
Camera 3
Camera 4
Factory network
The FlexLoader Vision PC can be connected to a factory network. The PC network
connection is named Factory on physical port PoE2.
Please refer to the robot controller product manual for setting the robot IP
configuration.
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
Note
If no factory network is used, the "PoE2" port can be used to connect and power
a second camera.
Otherwise, use a PoE switch in order to connect more than one camera to the
"PoE1" port.
© Copyright 2014-2018 ABB. All rights reserved.
IP address
192.168.125.150
192.168.125.1
192.168.125.151
192.168.125.152
192.168.125.153
192.168.125.154
IP address
192.168.2.1
192.168.2.2
192.168.2.3
192.168.2.4
192.168.2.5
11 Commissioning
11.3.2 Settings
Gateway
192.168.125.1
192.168.125.1
192.168.125.1
192.168.125.1
192.168.125.1
192.168.125.1
Gateway
Do not specify gateway.
Do not specify gateway.
Do not specify gateway.
Do not specify gateway.
Do not specify gateway.
Continues on next page
153