ABB FlexLoader Vision Product Manual page 247

Operation with external operator panel
MasterSlave.xml
If a FlexLoader Vision Lite is controlled from the external operator panel, FlexLoader
Vision must be configured as Slave (through TCP(IP).
Then the configuration file MasterSlave.xml must contain valid data for the IP
address of the external panel as well as the port it is to communicate on.
xx1800000528
MasterHandler.xml
If a FlexLoader Vision Lite is controlled from the external operator panel, the
following parameters must be changed in MasterHandler.xml on that external
operator panel.
xx1800000970
FlexLoaderVisionLite.xml
The FlexLoaderVisionLite.xml file must be configured. If an external operator
panel is used, this file must be available for both FlexLoader Vision and
MasterHandler.
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
• Specify the language as per requirements.
• Specify the IP address of the FlexLoader Vision computer as well as the port
number (same if specified in MasterSlave.xml).
• The values for the hasFlexLoaderVisionInterface, hasTeachIn and
teachInType parameters are specified according to the image below.
© Copyright 2014-2018 ABB. All rights reserved.
14 FlexLoader Vision Lite
14.5 FlexLoader Vision Lite configuration
Continues on next page
Continued
247