Table of Contents
Advertisement
System structure
A FlexLoader Vision Lite system is usually made up as follows:
xx1800000277
The operator interface of FlexLoader Vision Lite can be displayed in two ways:
Operating modes
The following standardized operating modes are supported:
General operation
The general operation of FlexLoader Vision, as well as installation and configuration,
is described in the first part of this manual.
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
•
Integrated in FlexLoader Vision (and then run on the FlexLoader Vision
computer).
•
On the operating panel of the lathe, as a Master to FlexLoader Vision. There
it is possible to choose details, start and stop the system, and perform
teachins of new parts.
•
First loading in main-spindle, then unloading from main- or sub-spindle.
•
First unloading from main or sub-spindle, then loading in main-spindle.
•
Unloading from sub-spindle. No loading is performed. (Used with bar feeders.)
•
Handling of remains.
•
After unloading, the selected actions are carried out according to the actions
chosen on the Options tab.
•
Both one and two spindle lathes are supported.
© Copyright 2014-2018 ABB. All rights reserved.
14 FlexLoader Vision Lite
14.1 Introduction
Continued
221
Advertisement
Table of Contents
