Table of Contents
Advertisement
10 Installation
10.1 PC installation
Continued
Connect the PC to the robot with a network cable. Make the connection from
connector LAN on the PC to the internal network connector LAN2 of the robot
controller. If necessary use a network switch.
We recommend a power supply with 24 VDC, supporting the maximum power-up
current of 3.6 A.
Prepare the power connector latch and connect both power supply and protective
earth to it according to the designation shown on the PC.
Use the screws on the power connector latch to secure it into place in the power
connector.
xx1800002004
Pos.
A
B
C
Switch on power and check that the PC is booting as expected.
Continues on next page
128
Description
Power connector
Power connector latch
Screws
Note
FlexLoader Vision software is always pre-installed on the PC.
© Copyright 2014-2018 ABB. All rights reserved.
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
Advertisement
Table of Contents
