Table of Contents
Advertisement
1-3-18
Setting - General(1) Screen - Part 3
1
4
1
Default Speed
Set the default speed applied when a job is
submitted.
Allowable Range: -7, -6, ... -1, - (default), +0, ... +5
This speed will be reflected to the feed speed
displayed on the Run - Setting screen.
2
Code 39 Full Ascii
Check the box when the barcode to be printed on
the sheet corresponds to the Code 39 Full Ascii.
3
Hot Folder
If a JDF file is put in the hot folder, it is submitted in
the pending job list automatically.
If you click here when the hot folder
Mark here to make
is enabled. the Selection screen of
the hot folder
hot folder will be displayed.
enabled.
SmartStacker User's Manual
Finishing Line Controller Screen Descriptions
4
Job ID digits
Set the number of digits to be read as a job ID among
the barcode printed on the sheet.
Example:
AAAABBCC
Job ID
Digits to start
reading the job ID
AAAABBBB
In case of reading the job ID to its rear end
2
3
Number of digits
to read
Set the number as
large as possible
for the number of
digits to read
97
Advertisement
Table of Contents
