Table of Contents
Advertisement
Code
Sheet remains at 2nd process unit exit sensor or
signal wiring disconnected
309
When the machine was started, the sheet exit
signal did not turn off and turn on again. Sheets
may be jammed at B260. Or, the wiring for the
sheet exit signal is disconnected.
Sheet has not arrived at switching timing sensor
310
The B310 was not turned on within the specified
time.
Sheet remains at switching timing sensor
311
The B310 has remained on for longer than the
specified time.
Too many sheets between 2nd process unit exit
sensor and switching timing sensor
312
The number of sheets between B260 and B310
exceeded the specified number.
Too many sheets passed switching timing sensor
313
B310 detected the sheet that had not pass B260.
Sheet has not arrived at speed reduction timing
sensor
320
The B320/B330 was not turned on within the
specified time.
Sheet remains at upper speed reduction timing
sensor
321
The B320 has remained on for longer than the
specified time.
Too many sheets between switching timing
sensor and speed reduction timing sensor
322
The number of sheets between B310 and B320/
B330 exceeded the specified number.
Too many sheets passed speed reduction timing
sensor
323
B320/B330 detected the sheet that had not pass
B310.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Remove the sheet jammed at the 2nd process
unit. If this error code appeared even though
the sheet is not jammed, check the B260 sensor
is not dirty. (See page 371 for the cleaning
instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B260 sensor is not dirty. (See
page 371 for the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B310 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B260 sensor is not dirty. (See page
371 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B310 sensor is not dirty. (See page
372 for the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B310 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B320 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B310 sensor is not dirty. (See page
372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the either of B320 or B330 is not dirty. (See
page 372 for the cleaning instruction.)
Solutions
217
Advertisement
Table of Contents
