Table of Contents
Advertisement
1-2-8
Run - Setting Screen - Part 2 (for Merge Stacker)
1
Supporting Air
When the vacuum belts are transporting a sheet
to the top of the stack in the Merge Stacker, air is
supplied to support sheet. The amount of air can be
adjusted here.
Use the smallest amount of air that will provide
reliable operation. If you are running thin or soft
sheets, and they are bent and do not stack correctly,
increase the amount of air.
2
Amount of Upward Vacuum of the
Vacuum Belt
This sets the amount of vacuum provided by the
vacuum belt in the Merge Stacker.
Usually this should be set to maximum.
If you are running thin sheets which do not separate
from the belt when they reach the stopper, reduce
the vacuum.
SmartStacker User's Manual
SmartStacker Screen Descriptions
3
Jogging Motion On/Off
This turns the jogging motion in the Merge Stacker
on or off.
This is the standard setting. The stopper
will jog every sheet.
The stopper will not jog the sheets.
4
Bypass for the Merge Stacker
This turns the jogging motion in the Merge Stacker
on or off.
Sheets are stacked on the merge stacker.
Normally, select this button.
This button is currently not available.
1
2
3
4
35
Advertisement
Table of Contents
