Table of Contents
Advertisement
SmartStacker Screen Descriptions
1-2-21
Setting - Size Setting Screen - Only for Offline System - Part 3
5
1
Gutter Trim Width - Short Side
If you have turned on the gutter trim function, this is
used to set the gutter trim width.
Allowable range for the gutter trim width:
6 to 15 mm / 0.24" to 0.6"
2
Gutter Trim On/Off - Short Side
This is used to set whether to trim the gutter of the
short side. See the explanation for item number 5 on
the page 46.
3
Scoring On/Off (Option)
This can be set only if you plan to divide the short
side of the sheet into two parts. Once you turn on this
function, the positive score can be made on the center
of the sheet.
4
Sheet Thickness
Enter the thickness in µm of the sheet to be run.
This setting is used to adjust the how long to stack
table lowers in the Merge Stacker, to predict how
many pages can be stacked before the stacker is
full, and to determine the timing for delivery of the
pages.
48
6
5
Fine Adjustment Carry Over
Select this to carry over the fine
adjustment settings from the previous
job.
Use this for a new job, so the fine
adjustment values are cleared to zero.
6
Starting the Changeover After Home
Positioning
If this is selected, all of the parts of the machine
return to their home positions before the changeover
begins.
When the sheets on the feed table is raised to the
upper position and the changeover is started, the
buzzer sounds and the feed table is lowered for the
specified amount. After the changeover, the feed
table will be rising.
7
Starting the Changeover
If this is selected, the changeover starts immediately,
without the parts returning to their home positions.
When the sheets on the feed table is raised to the
upper position, the machine performs as same as
described above.
SmartStacker User's Manual
1
2
3
4
7
Advertisement
Table of Contents
