Table of Contents
Advertisement
1-2-20
Setting - Size Setting Screen - Only for Offline System - Part 2
1
2
3
1
Long Edge Trim On/Off
This sets the trim function when the long edge of
sheet is cut.
On: Edge is trimmed.
Off: Edge is not trimmed.
2
Long Edge Trim Width (Register side)
When the long edge trim function is turned on, enter
the value of the long edge trim width on the register
side (rear side).
3
Long Edge Trim Width (Non-registered
side)
When the long edge trim function is turned on,
the value of the long edge trim width on the non-
registered side (front side) is displayed.
The value is decided according to the sheet size
(untrimmed sheet), finished sheet width, division
number, long edge trim width (register side).
If you enter a value which is out of range, the value
will be displayed in red.
SmartStacker User's Manual
SmartStacker Screen Descriptions
4
Short Edge Trim On/Off
This sets the trim function when the short edge of
sheet is cut.
On: Edge is trimmed.
Off: Edge is not trimmed.
5
Short Edge Trim Width (Register side)
When the short edge trim function is turned on, enter
the value of the short edge trim width on the register
side (rear side).
6
Short Edge Trim Width (Non-registered
side)
When the short edge trim function is turned on,
the value of the short edge trim width on the non-
registered side (front side) is displayed.
The value is decided according to the sheet size
(untrimmed sheet), finished sheet length, division
number, short edge trim width (register side).
If you enter a value which is out of range, the value
will be displayed in red.
4
5
6
47
Advertisement
Table of Contents
