Table of Contents
Advertisement
If a Warning Screen is Displayed on SmartStacker
Warning
Code
32
32
33
59
60
61
62
76
89
348
Warning Screen
Up
Down
Causes and Solutions
See page 50 for details.
The Start button was pressed before the feed table
was raised. Raise the feed table.
When you click the Starting the Changeover button on
the Run - Main screen of the FLC, the job sent from the
FLC cannot be processed on the SmartStacker. Select
the job which can be processed on the SmartStacker.
The B2 stacker is full. Remove the stack.
The stack number set on the panel did not reach the
stack number which was delivered to the B2 Stacker.
Add sheets on the sheet feeder.
The counter mismatch error of the B2 Stacker
occurred. Check the screen and remove sheets from
the sheet feeder and the B2 stacker.
You changed a setting on the Setting screen, then went
to another screen without doing a changeover. It is
necessary to do a changeover.
It is time to clean the cooling fans.
Press the OK button and clean the fan. If you press
the Return button, this message icon will be displayed
again the next time the Power switch is turned on.
SmartStacker User's Manual
Advertisement
Table of Contents
