Table of Contents
Advertisement
Code
Too many sheets passed register section
entrance sheet pass sensor
373
B590 detected the sheet that had not pass B310.
Sheet has not arrived at register section offset
timing sensor
380
The B593 was not turned on within the specified
time.
Sheet remains at register section offset timing
sensor
381
The B593 has remained on for longer than the
specified time.
Too many sheets between register section
entrance sheet pass sensor and register section
offset timing sensor
382
The number of sheets between B590 and B593
exceeded the specified number.
Too many sheets passed register section offset
timing sensor
383
B593 detected the sheet that had not pass B590.
Sheet has not arrived at register section exit
sheet pass rear sensor
390
The B594 was not turned on within the specified
time.
Sheet remains at register section exit sheet pass
rear sensor
391
The B594 has remained on for longer than the
specified time.
Too many sheets between register section offset
timing sensor and register section exit sheet pass
rear sensor
392
The number of sheets between B593 and B594
exceeded the specified number.
Too many sheets passed register section exit
sheet pass rear sensor
393
B594 detected the sheet that had not pass B593.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Remove the sheets which are jammed. Also,
check the B590 is not dirty. (See page 372 for
the cleaning instruction.)
Remove the sheet which is jammed.
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B593 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B590 sensor is not dirty. (See page
372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B593 is not dirty. (See page 372 for
the cleaning instruction.)
Remove the sheet which is jammed.
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B594 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B593 sensor is not dirty. (See page
372 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B594 is not dirty. (See page 372 for
the cleaning instruction.)
Solutions
221
Advertisement
Table of Contents
