Table of Contents
Advertisement
Code
Sheet delay in upper transport section
The B332 was activated while the B322 was
345
turned on. (Sheets were delayed in the upper
transport section. At the merging point, the order
of sheets may change.)
Sheet has not arrived at lower transport section
sheet pass sensor
350
The B332 was not turned on within the specified
time.
Sheet remains at lower transport section sheet
pass sensor
351
The B332 has remained on for longer than the
specified time.
Too many sheets at lower transport section
352
The number of sheets between B330 and B332
exceeded the specified number.
Too many sheets passed lower transport section
sheet pass sensor
353
The number of the sheets detected by B332
exceeded the number of the sheets detected by
B330.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Check if the sheet thickness on the size setting
screen is correct.
If it is wrong;
In case of Near line or Inline
It should be corrected in the DFE.
In case of Offline
It can be corrected on the size setting screen.
Check if the trim is not jammed.
Also, check that the distance between the
stopper and the tail guide at the Merge Conveyor
is not too short.
Remove the sheet which is jammed. Also,
check if there is something to interrupt the
transportation of sheets. If this error code
appeared even though the sheet is not jammed,
check the B330 sensor is not dirty. (See page
372 for the cleaning instruction.)
If the same error occurs, check the distance
between stopper and the tail guide at the Merge
Conveyor is not short for the sheet. Also, check
if the sheet is not cut diagonally. If the sheet is
cut diagonally, see page 356 and adjust each
mechanism.
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B332 sensor is not dirty. (See
page 372 for the cleaning instruction.)
Remove the sheet which is jammed. Also, check
the B330 sensor is not dirty. (See page 372 for
the cleaning instruction.)
Remove the sheet which is jammed. Also, check
the B332 sensor is not dirty. (See page 372 for
the cleaning instruction.)
Solutions
219
Advertisement
Table of Contents
