Horizon Fitness SmartStacker User Manual page 250

If an Error Code Is Displayed on SmartStacker
Code
Absolute data lost 2.
(Amplifier display: dL2)
3329
The absolute data of the encoder is lost. (Multi-
turn data fault in encoder)
Absolute data lost 3.
(Amplifier display: dL3)
3330
The absolute data of the encoder is lost.
(Detection at power-on after an ET alarm)
Multi-turn data overflow
(Amplifier display: AF)
3331
Excessive servo motor revolutions
Initial error
(Amplifier display: iE)
The initial position inside the encoder is not
established.
3332
Additional Information
This error may occur when the power switch is
turned on while the servo motor is rotated by
hand.
Braking transistor error
(Amplifier display: rH3)
The frequency of the command pulse inside the
3333
servo amplifier is high.
2. 00 [MHz] or a higher frequency is detected at
the inlet of the position deviation counter inside
the servo amplifier.
Inverter no response
(Inverter display: N/A)
3340 The communication connection between the
servo amplifier and the control board P109512
(QPM-290) for the 2nd regist unit has not been
established.
Servo amplifier communication failure
(Amplifier display: N/A)
3341
The communication is not stable. A
communications data error occurred.
Drive power undervoltage
(Amplifier display: N/A)
3342
The voltage of the power supplied to the servo
amplifier is insufficient.
250
Description and Causes Solutions
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
Turn off the power. Wait about 30 minutes and
turn on the power again. If this error occurs
frequently, call your local dealer.
If this error occurs frequently, call your local
dealer.
Check if Q210 breaker is not tripped.
Check if Q210 breaker is not tripped.
If this error occurs frequently, call your local
dealer.
SmartStacker User's Manual