Horizon Fitness SmartStacker User Manual page 279

Code
CONT (control signal) error
(Amplifier display: ctE)
4314
The parameter stored in the servo amplifier is
incorrect.
Overload 1
(Amplifier display: oL1)
4315
The servo motor is mechanically locked.
Overload 2
(Amplifier display: oL2)
4316
The servo motor is mechanically locked.
Main power undervoltage
(Amplifier display: LvP)
4321
The power supplied to the servo amplifier falls
below the minimum specification voltage limit.
Internal braking resistor overheat
(Amplifier display: rH1)
4322 The power consumption of the braking resistor
built in the servo amplifier exceeds the upper
limit. (Detection is made at the internal electronic
thermal relay of the servo amplifier.)
External braking resistor overheat
(Amplifier display: rH2)
4323
The external regeneration resistor is overheated.
Braking transistor error
(Amplifier display: rH3)
4324
The regeneration handling transistor built in the
servo amplifier is damaged.
Deviation overflow
(Amplifier display: oF)
4325
A position deviation amount equivalent to servo
motor revolutions specified in deviation detection
overflow value is accumulated inside the servo
amplifier.
Amplifier overheat
(Amplifier display: AH)
4326
The temperature of the servo amplifier has
exceeded the allowable limit.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
If this error occurs frequently, call your local
dealer.
Check that nothing is preventing the Merge
Conveyor upper speed reduction roller from
moving. If this error occurs frequently, call your
local dealer.
Check that nothing is preventing the Merge
Conveyor upper speed recduction roller from
moving. If this error occurs frequently, call your
local dealer.
Close all the covers and make sure the
Emergency Stop button is released.
Additional Information
This error may be occurred even you open/close
the cover or turn on/of the Emergency Stop
quickly.
If this error occurs frequently, call your local
dealer.
Turn off the power. Wait about 30 minutes and
turn on the power again. If this error occurs
frequently, call your local dealer.
If this error occurs frequently, call your local
dealer.
Solutions
279