Table of Contents
Advertisement
5
Check that the rear edge of the stack is aligned with the table guide.
• If the rear edge of the stack is not lined up with the table guide, adjust the position of the feed
table by turning the adjusting nut near the front left corner of the feed table. (See page 180 for
details.)
6
Align the feed guide with the operator side of sheets.
7
Adjust the separator, blower air and side air if necessary. (See Chapter 5 for
details.)
SmartStacker User's Manual
Locking Knob
Loading the Sheets on the Sheet Feeder
Table Guide
The table guide is vertical.
The rear edge of the sheet
should line up with the
table guide.
Fit the guide on the
sheet edge.
121
Advertisement
Table of Contents
