Table of Contents
Advertisement
If an Error Code Is Displayed on SmartStacker
Code
Sheet remains at stack section entrance sheet
pass rear sensor
531
The B520 has remained on for longer than the
specified time.
Too many sheets between transport speed
reduction timing sensor and stack section
entrance sheet pass rear sensor
532
The number of sheets between B510 and B520
exceeded the specified number.
Too many sheets passed stack section entrance
sheet pass rear sensor
533
B520 detected the sheet that had not pass B510.
B520 detected too small sheet
534
B520 may detect a trim strip of sheet.
Too many sheets passed stack section entrance
sheet pass rear sensor
535
B520 detected the sheets more than sheet
information received from feeder.
Parallel stacking count error
536
There was the counting difference on the parallel
stacking sheets.
Sheet jam during parallel stacking operation
537
There was a difference longer than specified time
on the detection of B520 and B526.
Sheet has not arrived at bypass exit sheet pass
sensor
540
The B550 was not turned on within the specified
time.
Sheet remains at bypass exit sheet pass sensor
541
The B550 has remained on for longer than the
specified time.
Too many sheets between slope section sheet
pass sensor and bypass exit sheet pass sensor
542
The number of sheets between B512 and B550
exceeded the specified number.
226
Description and Causes
Solutions
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B520 sensor is not dirty. (See
page 374 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B510 sensor is not dirty. (See page
374 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B520 is not dirty. (See page 374 for
the cleaning instruction.)
Check the stacked sheets. Also, check the B520
is not dirty. (See page 374 for the cleaning
instruction.)
Remove the sheets which are jammed. Also,
check the B520 is not dirty. (See page 374 for
the cleaning instruction.)
Check whether the sheets are not jammed.
Check whether the sheets are not jammed.
Remove the sheet which is jammed.
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B550 sensor is not dirty. (See
page 374 for the cleaning instruction.)
Remove the sheets which are jammed. Also,
check the B512 sensor is not dirty. (See page
374 for the cleaning instruction.)
SmartStacker User's Manual
Advertisement
Table of Contents
