Table of Contents
Advertisement
SmartStacker Screen Descriptions
1-2-9
Run - Setting Screen - Part 3 (for B2 Stacker)
3
1
Supporting Air
When the vacuum belts are transporting a sheet to
the top of the stack in the B2 Stacker, air is supplied
to support sheet. The amount of air can be adjusted
here.
Usually this should be set to maximum. Use
the large amount of air that will provide reliable
operation. If you are running thin or soft sheets, and
they are bent and do not stack correctly, increase
the amount of air.
2
Adjustment of Upward Vacuum of the
Vacuum Belt
This sets the amount of vacuum provided by the
vacuum belt in the B2 Stacker.
If the sheet does not reach the stopper in the stack
section, press
to increase the amount of
vacuum. If you are running thin sheets which do not
separate from the belt when they reach the stopper,
or if a jam occurs, reduce the vacuum.
36
3
Amount of Downward Vacuum of the
Register Guide Section
This sets the amount of vacuum provided by the fans
below the register section in the Merge Conveyor. Increase
the vacuum air if the sheets do not align with the register
guide and result in misaligned stack of sheets.
If a jam caused by hitting the register guide (any scratches or
transport error caused by sheet bent) occurs, press
reduce the vacuum.
Register Guide
You can see the sheet flow from above the sheet receiving
section of the Merge Conveyor and the B2 Stacker. Check that
the sheet is aligned to the guide.
SmartStacker User's Manual
1
2
to
Register Section
Advertisement
Table of Contents
