Table of Contents
Advertisement
1-3
Finishing Line Controller Screen Descriptions
This manual includes the operating procedures for the FLC system software (V.1.41.0.0).
1-3-1
Run - Main Screen - Part 1
1
2
1
Machines Used in the Line
The name and the icons of the machines used in the finishing
line are displayed here. On the screen shown above, just the
SmartStacker is being used. See page 102 for details.
If the machine image is shown in light colors, the machine
cannot execute the job because the power is turned off, or a
signal cable is not connected.
2
Status Indicators
The status of the machine is displayed using icons.
Power
The machine cannot execute the job
Off:
because the power is turned off, or a
signal cable is not connected.
Jam:
A jam has occurred.
Emergency
The Emergency Stop button has
Stop:
been pressed.
Cover
A safety cover has been opened.
Open:
Other:
Another type of error has
occurred.
Stopped: The machine is stopped temporarily because it is
being maintained, or it has broken.
80
Cleanup: The machine is being cleaned.
Changeover: The machine is doing a setup
change (changeover).
Pause:
A job has started but sheet is not
fed yet.
Running: A job is running.
Stopping: The stop button has been
pressed. The machine continues
processing the block or job until it
gets to an end.
Ready:
The machine is ready to run a job.
3
Warning Icons
If an error has occurred and must be corrected, the icons
shown below will appear. A warning will not stop the
machine.
The stack or the trim bin is full.
Other warning
SmartStacker User's Manual
3
Advertisement
Table of Contents
