Table of Contents
Advertisement
Code
Waste full error
171
The light from B150 was blocked for longer than
the specified time.
Trim full error
172
The light from B151 was blocked for longer than
the specified time.
2nd Regist Unit / 2nd Process Unit: 200-
2nd regist unit Emergency Stop
200
The S200 Emergency Stop button is pressed.
90-degree turn conveyor cover open
201
The 90-degree turn conveyor cover (S201) is
open.
2nd regist unit top cover open
202
The 2nd regist unit top cover (S202) is open.
2nd regist unit front cover open
203
The 2nd regist unit front cover (S203) is open.
2nd process unit top cover open
204
The 2nd process unit top cover switch (S204) is
open.
2nd process unit right cover open
205
The 2nd process unit right cover (S205) is open.
2nd process unit left cover open
206
The 2nd process unit left cover switch (S206) is
open.
Sheet remains at 1st process unit exit sensor or
signal wiring disconnected
209
When the machine was started, the sheet exit
signal did not turn off and turn on again. Sheets
may be jammed at the B140 or B141. Or, the
wiring for the sheet exit signal is disconnected.
Sheet has not arrived at gripper timing sensor
210
Neither B211 nor B212 was turned on within the
specified time.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Remove the full waste sheets. If this error
code appeared even though the waste sheets
are not full, check the B150 sensor and mirror
are not dirty. (See page 370 for the cleaning
instruction.)
Remove the trim at the trim chute.If this error
code appeared even though no trim at the trim
chute, check the B151 and mirror are not dirty.
(See page 370 for the cleaning instruction.)
Release the Emergency Stop button.
Close the cover.
Remove the sheet jammed at the 1st process
unit. If this error code appeared even though the
sheet is not jammed, check the either of B140
sensor or B141 sensor is not dirty. (See page
370 for the cleaning instruction.)
Remove the sheet jammed at the 1st process
unit. If this error code appeared even though the
sheet is not jammed, check the either of B140
sensor or B141 sensor is not dirty. (See page
370 for the cleaning instruction.)
Solutions
213
Advertisement
Table of Contents
