Table of Contents
Advertisement
Code
Too many sheets passed bypass exit sheet pass
sensor
543
B550 detected the sheet that had not pass B512.
Pallet setting failure
590
The B525 was turned on.
B2 Stacker full
591
The B543 or B544 was turned on during
operation.
B2 Stacker Slope Section Unlock Error
592
The Slope Section Unlock Detection Sensor
B511 was turned off during operation.
Sheet Feeder: 600-
Sheet feeder Emergency Stop
600
The S901 Emergency Stop button is pressed.
Misfeeding
611
The sensor B912 was not turned on within the
specified time after the Y911 feed valve turned
on.
Sheet remains at feed section
612
The sensor B912 remained on for longer than the
specified time.
Double feed error
613
The sensor B912 detected more than one sheet.
Feed table raised beyond limit
614
While the feed table was rising, S920 remained
on for longer than the specified time.
Feed table reached upper limit
628
The S912 feed table upper limit switch was
turned on while the Start button was pressed.
Panel: 900-
Configuration Error (B2 Stacker is not connected)
900
This job cannot be processed under the current
system setting. (The B2 Stacker is not turned on
the Service - System Setting screen.)
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Remove the sheets which are jammed. Also,
check the B550 is not dirty. (See page 374 for
the cleaning instruction.)
Set the pallet correctly.
Remove the stacked sheets.
Set (raise) up the slope section and start the job.
Release the Emergency Stop button.
See page 357 and adjust each mechanism.
Remove the sheet which is jammed.
See page 360 and adjust each mechanism.
Lower the position of the feed table height
sensor.
Lower the position of the feed table height
sensor.
In case that the job that the sheets are delivered
to the B2 Stacker is processed, it is necessary to
turn on the B2 Stacker of the Service - System
Setting screen. Call your local dealer.
Solutions
227
Advertisement
Table of Contents
