Table of Contents
Advertisement
Double Feed Stop Plate Adjustment
Valve Housing Adjustment
If you are using thick or sheets that curl up:
Move the suction point 2 to 3 mm / 0.08" to 0.12" back (direction A), so that the sheet is not caught by
the feed rotor or taken around the rotor. The sheet should be straightened to be fed reliably.
If you are using thin or sheets that curl down:
Move the suction point 2 to 3 mm (0.08" to 0.12") forward (direction B). This will feed the front edge so
that it prevents the sheet from hitting the entrance of the register guide.
Loosen the locking knob to adjust
the position of the suction point.
Locking Knob
SmartStacker User's Manual
If double feeding occurs often, raise
the plate a bit.
B
A
B
Adjusting the Sheet Feeder
A
26030
30102E1
189
Advertisement
Table of Contents
