Changeover; Before A Changeover - Horizon Fitness SmartStacker User Manual

2-2

Changeover

2-2-1

Before a Changeover

Receiving a Job
In case the SmartStacker runs in a Near Line system, job is defined at the upstream system, and
the HP DFE sends the job to the FLC. The FLC displays the received job in the list of Pending job.
Example of Use of Flag for Loading Fine Adjustment
If the SmartStacker is in a Near Line system, it saves the details of fine adjustment that has ever been done.
If you run several jobs of sheets of same size, you can load the sheets for several jobs
together on the feeder and run the jobs continuously by using a banner sheet for each job
and selecting automatic run. During this automatic run, the machine does not stop between
the jobs for fine adjustment because it does changeover and feeding continuously. You can
stop feeding and do fine adjustment by setting a flag for a job.
In case the SmartStacker saves a job that needs fine adjustment, and the same adjustment
should be done every time to repeat the job, follow the procedure shown below.
Preparation
Save the fine adjustment val-
ues to the memory.
1
Save the job that includes fine adjustment on the Memory screen of the SmartStacker.
2
When the FLC receives the job from the HP DFE, set the flag on the FLC screen.
Job A
Job B
Job C
Job D
Job E
Additional Information
In the example above, the second flag returns the
job to run without fine adjustment. You can also
load another adjustment by using the flag.
112
Job A
Job B
0.8
Job C
Job D
Job E
Load the adjustment.
Delete the adjustment.
No Adjustment
0
Load the adjustment on the Memory screen.
0.8
Delete the adjustment on the Size Setting screen.
0
SmartStacker User's Manual