Table of Contents
Advertisement
6
Adjust the blower air.
Best Setup for Blower Air -
• Adjust the blower air using the blower pressure levers and the blower position adjusting knobs.
The vacuum piston should lift up the top sheet, and below that about 10 to 15 sheets at the top
of the stack should be separated.
Note
Normally, the blower air on both sides
should be set evenly. If the sheets are
blown unevenly on either side of the vac-
uum piston because the paper is curved,
correct the imbalance using the blower
pressure levers. If the blower pressure is
too strong, this can cause double feeding.
SmartStacker User's Manual
Adjusting the Sheet Feeder
Blower Air
Blower Position
Adjusting Knob
Separation Air
10 to 15
Sheets
23073
10401A7
Separator
23073
30101A2
Blower Pressure
Levers
183
Advertisement
Table of Contents
