Table of Contents
Advertisement
If an Error Code Is Displayed on SmartStacker
Code
Circuit trouble
(Amplifier display: ct)
3308
There is a fault in the supply power voltage inside
the servo amplifier. There may be a failure in the
internal circuit.
Memory error
(Amplifier display: dE)
3309
The parameter stored in the servo amplifier is
damaged.
Fuse broken
(Amplifier display: Fb)
3310
The fuse in the main circuit of the servo amplifier
is blown.
Motor combination error
(Amplifier display: cE)
3311
The combination of the servo amplifier and the
motor is not correct.
Braking transistor overheat
(Amplifier display: tH)
3312
The regeneration handling transistor built in the
servo amplifier is overheated.
Encoder communication error
(Amplifier display: Ec)
3313
Communications with the internal encoder of the
servo motor fails.
CONT (control signal) error
(Amplifier display: ctE)
3314
The parameter stored in the servo amplifier is
incorrect.
Overload 1
(Amplifier display: oL1)
3315
The servo motor is mechanically locked.
Overload 2
(Amplifier display: oL2)
3316
The servo motor is mechanically locked.
248
Description and Causes
Solutions
Turn off the power. Wait about 30 minutes and
turn on the power again. If this error occurs
frequently, call your local dealer.
Turn off the power. Wait about 30 minutes and
turn on the power again. If this error occurs
frequently, call your local dealer.
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
Check that nothing is preventing the gripper from
moving at the 2nd regist unit. If this error occurs
frequently, call your local dealer.
Check that nothing is preventing the gripper from
moving at the 2nd regist unit. If this error occurs
frequently, call your local dealer.
SmartStacker User's Manual
Advertisement
Table of Contents
