Table of Contents
Advertisement
5-2-2
Adjusting the Trim Width - Short Edge
If the bleed and gutter trim posi-
tions on all the pages are shifted
up or down, adjust the setting here.
Feed
Direction
Doing a test feed using the Adjusting Mode screen
Use the Administrator - Adjusting Mode screen to check if the sheets are being cut correctly. The cut sheets will
stop at the 90-degree Turn Conveyor. This will make it easier to check the accuracy of the cuts.
SmartStacker User's Manual
Adjusting the Cutting Positions
1
Enter "1."
➡ The default setting is "0."
2
Press the Start button and feed a
sheet.
➡ The sheet is processed through the First
Process Unit and stopped at the stopper in the
90-degree Turn Conveyor.
3
Check whether the sheet has been cut
correctly.
4
If the quality is OK, enter "0" to return to
the normal mode.
191
Advertisement
Table of Contents
