Table of Contents
Advertisement
If an Error Code Is Displayed on SmartStacker
Code
Scoring unit not installed
The connector for scoring unit was unplugged
284
while the machine was running, or the machine
was started while the connector for scoring unit
was unplugged.
Waste full error
291
The light from B252 was blocked for longer than
the specified time.
Trim full error
292
The light from B253 was blocked for longer than
the specified time.
Merge Conveyor: 300-
Merge conveyor Emergency Stop
300
The S300 Emergency Stop button is pressed.
Merge conveyor entrance transport section top
cover open
301
The entrance transport section top cover (S301)
is open.
Dual transport section top cover open
302
The dual transport section top cover (S302) is
open.
Merge conveyor entrance transport section right
cover open
303
The entrance transport section right cover (S303)
is open.
Merge conveyor entrance transport section left
cover open
304
The entrance transport section left cover (S304)
is open.
Merge conveyor exit transport section front cover
open
305
The exit transport section front cover (S305) is
open.
Drawer unlock
308
The start button was pressed when the drawer
was unlocked.
216
Description and Causes
Solutions
Install the scoring unit correctly.
Remove the full waste sheets. If this error
code appeared even though the wast sheets
are not full, check the B252 sensor and mirror
are not dirty. (See page 371 for the cleaning
instruction.)
Remove the trim at the trim chute. If this error
code appeared even though no trim at the
delivery section, check the B253 and mirror
are not dirty. (See page 371 for the cleaning
instruction.)
Release the Emergency Stop button.
Close the cover.
Check the both of top and bottom drawer are
closed.
SmartStacker User's Manual
Advertisement
Table of Contents
