Table of Contents
Advertisement
Setting the Control Panel - When using the B2 Stacker
3-2-3
Starting a Job
1
Load the sheets and raise the feed table. (See page 118.)
➡ When the feed table sensor detects the upper surface of the stack, the feed table stops automat-
ically. The suction head is then lowered.
2
Set the pallet on the B2 Stacker.
• Move the pallet along the guide on the entrance side, and set the pallet so that it fits the guide on
the far side.
3
Press the Motor/Feed Start button.
➡ The air pump starts and the suction head picks up the top sheet. The sheet is fed and the ma-
chine processes the sheet.
➡ The cut sheets are stacked and delivered according to the delivery setting.
4
Press the Motor/Feed Stop button to stop the
sheet cutting operation.
5
Before you turn the power off after finishing the
operation, lower the feed table and the pallet to
the floor.
6
Remove the stack from the B2 Stacker.
162
Additional Information
The pallet moves up when the Motor/Feed
Start button is pressed, however, when you
raise the pallet in advance, you can get an
early start.
Sheet Feeder Control Panel
B2 Stacker Control Panel
SmartStacker User's Manual
Advertisement
Table of Contents
