Adjusting The Sheet Feeder; Adjusting The Position Of The Suction Head; Adjusting The Feed Table Position - Horizon Fitness SmartStacker User Manual

5-1

Adjusting the Sheet Feeder

5-1-1

Adjusting the Position of the Suction Head

Run - Fine Adjustment Screen
5-1-2

Adjusting the Feed Table Position

Check to see that the rear edge of the stack lines up with the table guide. If the rear edge of the stack
does not line up with the table guide, adjust the position of the feed table by turning the adjusting nut
near the front left corner of the feed table.
180
Position of Suction Head
Down Up
Set Register Pin
If you need to adjust the position of the
suction head, use the screen shown to
the left.
Table Guide
The table guide is vertical.
The rear edge of the stack
should line up with the
table guide.
This adjustment can only be made if the
feed table is positioned higher than the
guide block.
SmartStacker User's Manual
Guide Block