Table of Contents
Advertisement
Warning
Code
27
27
28
28
29
30
31
SmartStacker User's Manual
If a Warning Screen is Displayed on SmartStacker
Warning Screen
Causes and Solutions
Check if the stack table is not at the lower limit.
Recovery after overloading the stack table up/down
mechanism.
1. Remove any stacks on the stack table.
- Press
to raise the stack table, then remove
any foreign objects under the stack table or around
the chains.
- Press
to return the stack table to the home
position.
2. Turn off the Power switch and wait about 30
seconds, then turn on the Power switch.
The stack reached the maximum height for the stacker
and a block was divided.
When you do not want to divide the stack
1. Press
.
➡ The Run-Main screen is displayed.
2. You can reduce the number of blocks included in a
stack using the Run-Main screen. This will prevent
the stack from being divided
3. Start the production again.
When you do not care about the stack being divided
1. Press
. Then, system will start to run again
with the same settings.
The output conveyor is full. Remove the stacks on the
conveyor.
It is time to replace the cutter units.
Press the OK button and replace the cutter. If you
press the Return button, this message icon will be
displayed again the next time the Power switch is
turned on.
It is time to clean the sensors.
Press the OK button and clean the sensors. If you
press the Return button, this message icon will be
displayed again the next time the Power switch is
turned on.
347
Advertisement
Table of Contents
