Table of Contents
Advertisement
Loading a Pallet on the Feed Table
The sheet edge indicator
produces a red laser line.
Align the rear edge of the
sheet with this line.
Laser Line
Loosen the locking knob and move the feed
guide to the operator side. This is to prevent
the feed guide from hitting against the sheets
when the feed table is lifted in later step.
SmartStacker User's Manual
Loading the Sheets on the Sheet Feeder
• This laser line is produced for 5 minutes
Sheet Edge
Indicator
• If the laser line goes out, press the but-
23073
10301A6
If there is a gap between the
feed head plate and the stack,
push the upper part of the
stack toward the feed rotor to
reduce the gap.
Place so that the edge of
the pallet is lined up with
the feed head plate.
Note
after the feed table reaches the lower
limit.
tons below to turn on the line again.
If the height of feed table is less than
about 120 mm / 4.72"
• Press the Feed Table Down button.
If the height of feed table is above about
120 mm / 4.72"
• Press the Feed Table Up and Feed
Table Down buttons at the same time.
119
Advertisement
Table of Contents
