Table of Contents
Advertisement
If an Error Code Is Displayed on SmartStacker
Code
Fork up/down motor M431 home positioning error
2402
The M431 motor did not return to the home
position within the specified time after the start of
the home positioning.
Stack Holding Plate Adjusting Motor M449 Home
Positioning Error
2403
The M449 motor did not return to the home
position within the specified time after the start of
the home positioning.
Stack Section Stopper Adjusting Motor M429
Home Positioning Timeout Error
2411
The M429 motor did not complete the
changeover in 8 seconds after delivery of stack.
B2 Stacker Sheet Separate Plate Height
Adjusting Motor Home Positioning Error
2501
The M530 motor did not return to the home
position within the specified time after the start of
the home positioning.
B2 Stacker Stopper Home Positioning Error
2503
The M531 motor did not return to the home
position within the specified time after the start of
the home positioning.
B2 Stacker Vacuum Belt Unit Home Positioning
Error
2504
The M547 motor did not return to the home
position within the specified time after the start of
the home positioning.
B2 Stacker Stack Sheet Rear Pusher Home
Positioning Error
2505
The M532 motor did not return to the home
position within the specified time after the start of
the home positioning.
B2 Stacker Stack Sheet Front Pusher Home
Positioning Error
2506
The M533 motor did not return to the home
position within the specified time after the start of
the home positioning.
240
Description and Causes
Solutions
Check if there is something to interrupt the home
positioning operation.
SmartStacker User's Manual
Advertisement
Table of Contents
