Table of Contents
Advertisement
6-8
Problems with the Sheet Feeder
6-8-1
Misfeeding
Problem
The grip area of the
separator is too wide.
The separator is
producing too much
pressure.
The feed table is too low.
SmartStacker User's Manual
Top Sheet
in Stack
26030
40401C1
Possible Cause and Solution
• Decrease the grip area of the separator.
(See page 181 for details.)
26030
40401A1
• Decrease the separator angle.
(See page 181 for details.)
26030
40401B1
• Raise the feed table by adjusting the
height of the feed table sensor.
(See page 188 for details.)
• Normally, the feed table should stop when
the top sheet in the stack is about 8mm /
0.31" below the feed rotor.
About 8 mm
About 0.31"
357
Advertisement
Table of Contents
