Table of Contents
Advertisement
If an Error Code Is Displayed on SmartStacker
Code
No Error Codes
(Amplifier Display: N/A)
6150
An unexpected error occurs on the servo
amplifier.
(An error which does not correspond to any of the
errors 6100 through 6149 has occurred.)
B2 Stacker QPM-307 (4) CUnet Error: 6501-6599
6501-6527
Problem with M534 stack sheet center pusher
6528-6530
motor
6531-6549
6550-6577
Problem with M535 stack sheet end pusher
6578-6580
motor
6581-6599
A910 Inverter for Feed Table Up/Down Motor: 6800-6899
Inverter no response
(Inverter display: N/A)
The communication connection between the
6800
inverter, the reinforced insulation communication
board P110413 (QPW-943) and the control board
P109512 (QPM-290)for the sheet feeder has not
been established.
Inverter communication error
(Inverter display: N/A)
6801
The control board P109512 (QPM-290) for the
sheet feeder P109512 (QPM-290) received NAK
several times from the inverter.
Overcurrent during acceleration
(Inverter display: E.OC1)
6810
During acceleration, the output current of the
inverter became double the rated current
Overcurrent during constant speed
(Inverter display: E.OC2)
6811
During constant-speed operation, the output
current of the inverter became double the rated
current.
Overcurrent during deceleration
(Inverter display: E.OC3)
6812
During deceleration, the output current of the
inverter became double the rated current.
328
Description and Causes
Solutions
If this error occurs frequently, call your local
dealer.
If this error occurs frequently, call your local
dealer.
Close all the covers and make sure the
Emergency Stop button is released.
If this error occurs frequently, call your local
dealer.
SmartStacker User's Manual
Advertisement
Table of Contents
