Table of Contents
Advertisement
Code
Sheet has not arrived at gate timing sensor
250
The B251 was not turned on within the specified
time.
Sheet remains at gate timing sensor
251
The B251 has remained on for longer than the
specified time.
Too many sheets at gate timing sensor
252
The number of sheets between B251 and B260
exceeded the specified number.
Sheet has not arrived at 2nd process unit exit
sensor
260
The B260 was not turned on within the specified
time.
Sheet remains at 2nd process unit exit sensor
261
The B260 has remained on for longer than the
specified time.
2nd process unit rejection error
271
B260 detected a sheet that should not have
passed the exit.
2nd process cutter cassette 1 not installed
The connector for cutter cassette 1 was
281
unplugged while the machine was running, or
the machine was started while the connector for
cutter cassette 1 was unplugged.
2nd process cutter cassette 2 not installed
The connector for cutter cassette 2 was
282
unplugged while the machine was running, or
the machine was started while the connector for
cutter cassette 2 was unplugged.
2nd process cutter cassette 3 not installed
The connector for cutter cassette 3 was
283
unplugged while the machine was running, or
the machine was started while the connector for
cutter cassette 3 was unplugged.
SmartStacker User's Manual
Description and Causes
If an Error Code Is Displayed on SmartStacker
Remove the sheet which is jammed.
Check the sensor LED. The LED is unstable if it is
blinking,
Check that there is not any object on the sheet path. If
this error code appeared even though the sheet
is not jammed, check the B232 sensor is not dirty.
(See page 371 for the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B251 sensor is not dirty. (See
page 371 for the cleaning instruction.)
Remove the sheet which is jammed. Also, check
the B251 sensor is not dirty. (See page 371 for
the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B251 sensor is not dirty. (See
page 371 for the cleaning instruction.)
Remove the sheet which is jammed. If this error
code appeared even though the sheet is not
jammed, check the B260 sensor is not dirty. (See
page 371 for the cleaning instruction.)
Remove the waste sheet which could not be
rejected. If this error code appeared even though
the sheet is not jammed, check the B260 sensor
is not dirty. (See page 371 for the cleaning
instruction.)
Install the cutter cassette 1 correctly.
Install the cutter cassette 2 correctly.
Install the cutter cassette 3 correctly.
Solutions
215
Advertisement
Table of Contents
