Table of Contents
Advertisement
Problem
The feed table is too high.
The double feed stop
plate is too low.
The vacuum piston is too
low.
The pump is producing
too much vacuum.
SmartStacker User's Manual
Top Sheet
in Stack
26030
40501C1
Problems with the Sheet Feeder
Possible Cause and Solution
• Lower the feed table by adjusting the
height of the feed table sensor.
(See page 188 for details.)
• Normally, the feed table should stop when
the top sheet in the stack is about 8mm /
0.31" below the feed rotor.
About 8 mm
0.31"
• Set the double feed stop plate in a higher
position.
(See page 189 for details.)
26030
40501D1
• Raise the vacuum piston.
(See page 181 for details.)
1 mm
0.04"
26030
40501E1
• Decrease the vacuum setting to reduce
the vacuum at the vacuum piston head
and the feed rotor.
(See page 182 for details.)
Vacuum
26030
40501F1
361
Advertisement
Table of Contents
