Table of Contents
Advertisement
SmartStacker Screen Descriptions
1-2-49
Information - Administrator - Adjustment Mode Screen
1
2
1
Individual Unit Adjusting Mode
Use this mode if you want to stop a sheet inside the
machine to check the adjustment for a particular
mechanism.
0: Non-stop (default setting)
1: The sheet stops at the stopper in the 90-degree
Turn Conveyor.
2: The sheet stops at the stopper in the Merge
Conveyor.
4: The Merge Stacker can be run as a stand-alone
unit.
21: The sheet stops just before the gripper releases
the sheet in the 90-degree Turn Conveyor.
22: The Gates Position in the 2nd Process Unit
(Aligned with the front gutter if you are doing 4
divisions in the 2nd Process Unit)
23: The Gates Position in the 2nd Process Unit
(Aligned with the center gutter if you are doing 4
divisions in the 2nd Process Unit)
24: The Gates Position in the 2nd Process Unit
(Aligned with the rear gutter if you are doing 4
divisions in the 2nd Process Unit)
76
34: The MC/MS production speed is not changed
even if the sheet gap is changed. (However, it
will be changed depending on the imposition and
thickness of the sheet.)
2
Go to the Information - Administrator -
Main screen
SmartStacker User's Manual
Advertisement
Table of Contents
