Show Vlan Association Subnet; Show Vlan Association Mac; Double Vlan Commands - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Acceptable Frame Types The types of frames that may be received on this port. The options
Ingress Filtering May be enabled or disabled. When enabled, the frame is discarded if this
GVRP
Default Priority The 802.1p priority assigned to tagged packets arriving on the port.

show vlan association subnet

This command displays the VLAN associated with a specific configured IP-Address and net
mask. If no IP address and net mask are specified, the VLAN associations of all the configured
IP-subnets are displayed.
Format
Mode
IP Address
Net Mask
VLAN ID

show vlan association mac

This command displays the VLAN associated with a specific configured MAC address. If no
MAC address is specified, the VLAN associations of all the configured MAC addresses are
displayed.
Format
Mode
Mac Address
VLAN ID

Double VLAN Commands

This section describes the commands you use to configure double VLAN (DVLAN). Double
VLAN tagging is a way to pass VLAN traffic from one customer domain to another through a
62 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
are 'VLAN only' and 'Admit All'. When set to 'VLAN only', untagged frames
or priority tagged frames received on this port are discarded. When set to
'Admit All', untagged frames or priority tagged frames received on this port
are accepted and assigned the value of the Port VLAN ID for this port. With
either option, VLAN tagged frames are forwarded in accordance to the
802.1Q VLAN specification.
port is not a member of the VLAN with which this frame is associated. In a
tagged frame, the VLAN is identified by the VLAN ID in the tag. In an
untagged frame, the VLAN is the Port VLAN ID specified for the port that
received this frame. When disabled, all frames are forwarded in accordance
with the 802.1Q VLAN bridge specification. The factory default is disabled.
May be enabled or disabled.
show vlan association subnet [<ipaddr> <netmask>]
Privileged EXEC
The IP address assigned to each interface.
The subnet mask
There is a VLAN Identifier (VID) associated with each VLAN.
show vlan association mac [<macaddr>]
Privileged EXEC
A MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that
are separated by colons, for example 01:23:45:67:89:AB. In an IVL
system the MAC address will be displayed as 8 bytes.
There is a VLAN Identifier (VID) associated with each VLAN.