Turning On/Off The Beep Feature - Keysight E4980A User Manual

System Configurations
SYSTEM CONFIG Page

Turning On/Off the Beep Feature

Functional Description
The E4980A/AL has a beep feature that generates beeps when one or more of
the following conditions occur:
• An error message or warning message has appeared.
• The instrument has completed open/short correction.
• The instrument has completed open/short/load correction at user-specified
frequency points.
• The DUT has failed the limit test or has been sorted as OUT OF BIN/AUX
BIN by the comparator.
• The DUT has passed the limit test or has been sorted into one of bins 1
through 9 by the comparator.
• You have turned on/off the key lock.
Regardless of whether the beep feature is on or off, beeps are generated
whenever:
• E4980A/AL starts up.
• You change the beep tone through the front panel.
The beep feature does not support volume control.
To set up the beep feature:
Step 1. Press [System].
Step 2. Press the SYSTEM CONFIG softkey.
Step 3. Use the cursor keys to select the BEEPER ENABLED field.
Step 4. Turn on or off the beep feature by pressing the appropriate softkey:
Softkey
ON
OFF
Keysight E4980A/AL Precision LCR Meter
Description
Turns ON the beep feature.
Turns OFF the beep feature.
1. You can use the BEEP field on the LIST SWEEP SETUP page or the COMP:BEEP com-
mand to turn on/off the beep feature for the comparator.
1
1
155