Keysight E4980A User Manual page 142

Configuring Measurement Conditions (Display and Function Related Settings)
LIMIT TABLE SETUP Page
Step 6. Move the cursor into the 2nd LOW field and enter the lower limit value for the
secondary parameter.
Step 7. Move the cursor into the 2nd HIGH field and enter the upper limit value for
the secondary parameter.
To configure the limit values for sequential mode:
Step 1. Press [Meas Setup].
Step 2. Press the LIMIT TABLE softkey.
Step 3. Using the cursor keys, select the BIN 1 LOW field.
Step 4. Enter the limit value using the entry keys. When you enter the value, the
softkey labels change to unit labels (p, n, u, m, x1).
If you want to clear your selected limit value, press the CLEAR softkey; also,
you can clear all the limit values for your selected bin by pressing the CLEAR
LINE softkey.
The LOW field accepts an entry for bin1 only and does not accept an entry
for bins 2 through 9. The value entered into the HIGH field for bin 1 is used
as the lower limit for bin 2, but the LOW field for bin 2 displays no value.
You can enter the lower or upper limit values using the HIGHx(-1) or
LOWx(-1) softkey.
Step 5. Repeat
bin 9 (BIN 9 HIGH).
Step 6. Move the cursor into the 2nd LOW field and enter the Lower limit value for
the secondary parameter.
Step 7. Move the cursor into the 2nd HIGH field and enter the upper limit value for
the secondary parameter.
To clear the entire table:
Step 1. Press [Meas Setup].
Step 2. Press the LIMIT TABLE softkey.
Step 3. Using the cursor keys, select the BIN field.
Step 4. Press the CLEAR TABLE softkey.
142
Step 4 using the cursor keys until you have entered the upper limit for
Keysight E4980A/AL Precision LCR Meter