Sweep Mode - Keysight E4980A User Manual

Configuring Measurement Conditions (Display and Function Related Settings)
LIST SWEEP SETUP Page

Sweep Mode

Functional Description
The list sweep feature of the E4980A/AL can perform automatic sweep
measurement by sweeping the frequency, signal level, or DC bias through a
maximum 201 sweep points. The list sweep feature supports two sweep
modes: sequential (SEQ) and step (STEP). In sequential mode, once the
E4980A/AL has been triggered, it performs sweep measurement throughout all
the defined sweep points. In step mode, the E4980A/AL steps to the next
sweep point each time it is triggered.
Figure 4-21 Sequential and step modes
To set up the list sweep measurement mode:
Step 1. Press [Meas Setup].
Step 2. Press the LIST SETUP softkey.
Step 3. Using the cursor keys, select the MODE field.
Step 4. Select your desired list sweep measurement mode by pressing the
appropriate softkey:
Softkey
SEQ
STEP
144
Description
Set the list sweep measurement mode to sequential mode.
Set the list sweep measurement mode to step mode.
Keysight E4980A/AL Precision LCR Meter