List:voltage - Keysight E4980A User Manual

SCPI Command Reference
E4980A/AL commands
:LIST:STIMulus:TYPE?
Description Selects the parameter types for the list sweep with two parameters. If you do
not want to specify the second parameter, enter NONE for it. When you do
specify the second parameter, its measurement range can be set.
Parameter
FREQuency (Preset value)
VOLTage
CURRent
BVOLtage
BCURrent
DCSVoltage
NONE (Preset value)
IRANge
FREQuency
VOLTage
CURRent
BVOLtage
BCURrent
DCSVoltage
Example of Use
viVPrintf(AgtE4980A/AL, "LIST:STIM:TYPE FREQ, VOLT" + vbLf, 0)
viVPrintf(AgtE4980A/AL, "LIST:STIM:DATA 1E3, 1, 2E3, 1.1, 3E3,
0.9" + vbLf, 0)
Equivalent key No equivalent key is available on the front panel.

:LIST:VOLTage

Syntax :LIST:VOLTage <point 1>,<point 2>,... ,<point n>
358
First Parameter
Selects frequency as the first stimulus parameter
Selects voltage as the first stimulus parameter
Selects current as the first stimulus parameter
Selects bias voltage as the first stimulus parameter
Selects bias current as the first stimulus parameter
Selects DC source voltage as the first stimulus
parameter
Second Parameter
Selects no second stimulus parameter. The same operation is
performed as the :LIST:FREQuency,
so on according to the first stimulus parameter.
Selects impedance range as the second stimulus parameter.
Selects frequency as the second stimulus parameter
Selects voltage as the second stimulus parameter
Selects current as the second stimulus parameter
Selects bias voltage as the second stimulus parameter
Selects bias current as the second stimulus parameter
Selects DC source voltage as the second stimulus parameter
Keysight E4980A/AL Precision LCR Meter
:LIST:CURRent and