Keysight E4980A User Manual page 262

Overview of Remote Control
Data Transfer
The ASCII data output format on the LIST SWEEP page is shown below. The
data loop is repeated according to the number of sweep points.
Figure 8-22 ASCII Format 2 (List Sweep)
The <DATA A>, <DATA B>, and <STATUS> formats are the same as the formats
on the MEAS DISPLAY, BIN No., or BIN COUNT page. Therefore, only the
<IN/OUT> format will be described here.
•
262
<IN/OUT> format:
The <IN/OUT> data shows the result of the list sweep's comparator
function.
-1: LOW
0: IN
+1: HIGH
When the comparator function of the list sweep measurement is not used,
the <IN/OUT> data output result is 0 (zero).
The data output formats for <IN/OUT> use the two-ASCII character
fixed-length format as follows.
SN (S:+/-, N: 0 to 1)
Keysight E4980A/AL Precision LCR Meter