List:stimulus:data; List:stimulus:mdata; List:stimulus:type - Keysight E4980A User Manual

SCPI Command Reference
E4980A/AL commands

:LIST:STIMulus:DATA

Syntax :LIST:STIMulus:DATA <Point 1 1stSTIM>,<Point 1 2ndSTIM>,<Point 2
1stSTIM>,<Point 2 2ndSTIM>,....,<point n 1stSTIM>,<point n 2ndSTIM>
:LIST:STIMulus:DATA?
Description Sets the list sweep with two parameters (first and secondary parameters). This
command allows you to sweep with two parameters. For example, you can
sweep at point no.1 with 1 kHz/1 V, point no. 2 with 2 kHz/1.1 V, and point no.
3 with 3 kHz/0.9 V. Both first and second parameters must be set unless the
second parameter of
9.9E37 should be set for any empty points. When the IRANge is selected as the
secondary parameter in the
<Point n 2ndSTIM> can selected within the value of
:FUNCtion:IMPedance:RANGe[:VALue].
Parameter
Range of n
Unit
Example of Use
viVPrintf(AgtE4980A/AL, "LIST:STIM:TYPE FREQ, VOLT" + vbLf, 0)
viVPrintf(AgtE4980A/AL, "LIST:STIM:DATA 1E3, 1, 2E3, 1.1, 3E3,
0.9" + vbLf, 0)
Equivalent key No equivalent key is available on the front panel.

:LIST:STIMulus:MDATa?

Syntax :LIST:STIMulus:MDATa?
Description Returns actual stimulus values for a list sweep with two parameters. This
command allows you to know the actual applied values after the auto polarity
function works. (Query Only)
Equivalent key No equivalent key is available on the front panel.

:LIST:STIMulus:TYPE

Syntax :LIST:STIMulus:TYPE
{FREQuency|VOLTage|CURRent|BVOLtage|BCURrent|DCSVoltage},{NONE|IRA
Nge|FREQuency|VOLTage|CURRent|BVOLtage|BCURrent|DCSVoltage}
Keysight E4980A/AL Precision LCR Meter
:LIST:STIMulus:TYPE
1. When the second parameter of
NONE, this parameter is not needed.
command is set to NONE. The value
:LIST:STIMulus:TYPE command, the value for
<Point n 1stSTIM>,<Point n 2ndSTIM>
1 to 201
Depends on :LIST:STIMulus:TYPE
:LIST:STIMulus:TYPE
1
command is set to
357