List Sweep Display Page - Keysight E4980A User Manual

Display Format

LIST SWEEP DISPLAY Page

LIST SWEEP DISPLAY Page
When you press the [Display Format] key and LIST SWEEP softkey, the LIST
SWEEP DISPLAY page appears. On this page in is possible to enter sweep
points and measurement limits of up to 201 frequencies, test signal levels, DC
bias, or DC source. The sweep points are automatically swept and the
measurement results are compared to the limits.
On the LIST SWEEP DISPLAY page, the sweep points are swept and the
measurement results are compared to the limits. During a sweep, an asterisk
mark (*) will appear on the left side of the sweep point currently being
measured. The following measurement controls can be set from this page
(Each field in parentheses is used for setting).
•
•
The sweep point list cannot be set from this page; it can only be set from the
LIST SWEEP SETUP page.
Figure 3-11
each field on this page.
You can set it so that a beep sounds when the sorting result is output. For
details, refer to
82
Sweep Mode of the List Sweep Measurement (MODE)
Confirmation for Each Page of the List Sweep Measurement (No. of fields)
shows the available fields and the softkeys that correspond to
"Beep Feature" on page 139.
Keysight E4980A/AL Precision LCR Meter