Table of Contents
Advertisement
Setting up Measurement Conditions and Display
Turning On/Off the Beep Feature
Turning On/Off the Beep Feature
Functional description
The E4981A has a beep feature that generates beeps when one or more of the
following conditions occur:
•
•
•
•
•
•
Regardless of whether the beep feature is on or off, beeps are generated
whenever:
•
•
The beep feature does not support volume control.
To set up the beep feature:
Step 1.
Press [System].
Step 2.
Press the SYSTEM CONFIG softkey.
Step 3.
Use the cursor keys to select the BEEPER ENABLED field.
Step 4.
Turn on or off the beep feature by pressing the appropriate softkey:
Softkey
ON
OFF
68
An error message or warning message has appeared.
The instrument has completed open/short correction.
The instrument has completed open/short/load correction at user-specified
frequency points.
The DUT has failed the limit test or has been sorted as OUT_OF_BIN,
AUX_BIN, OVLD or No contact by the comparator.
The DUT has passed the limit test or has been sorted into one of bins
1 through 9 by the comparator.
You have turned on/off the key lock.
E4981A starts up.
You change the beep tone through the front panel.
Description
Turns ON the beep feature.
Turns OFF the beep feature.
1. You can use the BEEP field on the LIMIT TABLE SETUP page or the :CALC:COMP:BEEP
command to turn on/off the beep feature for the comparator.
1
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
1
Advertisement
Table of Contents
